Guest MauroTheWall Inviato May 8, 2011 Segnala Inviato May 8, 2011 Allora nei pickups Voodoo il middle è reverse wind, se lo collego invertendo i fili, diventa un normale pickup? Non mi piace il suono dei reverse wind nelle posizioni intermedie. Cita
Gluca Inviato May 8, 2011 Segnala Inviato May 8, 2011 Al massimo sarà reverse wound :TRsorrisone: Cita
Ric67 Inviato May 8, 2011 Segnala Inviato May 8, 2011 Allora nei pickups Voodoo il middle è reverse wind, se lo collego invertendo i fili, diventa un normale pickup? Non mi piace il suono dei reverse wind nelle posizioni intermedie. i miei voodoo non hanno il middle reverse.... vendilo e comprati il middle non reverse :TRsorrisone: Cita
Guest Bru Inviato May 8, 2011 Segnala Inviato May 8, 2011 Al massimo sarà reverse wound :TRsorrisone: Florance li chiama reverse wind. Cita
Guest MauroTheWall Inviato May 8, 2011 Segnala Inviato May 8, 2011 http://www.voodoopickups.com/Strat%20Replacement.htm Ok, ma se inverto i fili? Cita
Guest scheggia impazzita Inviato May 8, 2011 Segnala Inviato May 8, 2011 la bobina è comunque avvolta in senso inverso Cita
Guest MauroTheWall Inviato May 8, 2011 Segnala Inviato May 8, 2011 la bobina è comunque avvolta in senso inverso Quindi non serve a 'na sega? Cita
Guest Bru Inviato May 8, 2011 Segnala Inviato May 8, 2011 Se può servire: RWRP stands for reverse wound reverse polarity. If you reverse the windings but not the polarity you will get hum canceling in 2 and 4 but your pickup will be out of phase with the other pickups and it'll sound thin. If you reverse the polarity of the magnets but you don't reverse the windings then you will get the same thin out of phase sound but without the advantage of hum canceling. If you reverse the windings and the polarity then the pickup will have hum canceling and it'll be in phase so it should sound good but when the hum is cancelled there will be some of the good tone that is cancelled out as well so it won't sound as fat as it would if all the pickups were wound the same direction with the same polarity. When all the pickups are wound the same direction with the same polarity you get the fatter sound in 2 and 4 than you would with an RWRP pickup but you also get hum hum. So the advantage of RWRP is no hum. The "disadvantage" is that that the tone is slightly thinner in 2 and 4. There are 2 ways to reverse the windings on the pickup. 1 of them changes the way the pickup sounds and the other doesn’t. One way to reverse the windings is to wind it like normal and then reverse the leads so end of the coil which is normally hot would be ground and the start of the coil which is normally ground would be hot. Doing this will make the pickup sound a little different and it’ll make the pickup hum a little more but it does effectively reverse the windings. The other way to reverse the windings is to physically spin the pickup the other direction when you wind it. This method does not change the tone of the pickup at. It will sound exactly as it did if it was wound in the “normal” direction. The way to revere the polarity depends on the type of pickup you have. If your pickup uses a ceramic bar magnet you will have to rip the magnet off, flip it over, and reglue it. If your pickup uses plastic bobbins and alnico magnets then you can push the magnets out and flip them over 1 at a time. If your pickup has a forbon (fiber) bobbin then you have to remagnatize the magnets with something like a neodymium magnet. Hey, someone, have you ever heard of anyone experimenting with using armalloy or armco cores, or comparing alnico pole pieces to neodymium, etc? I've got a bunch of little neodymium disks that I sometimes put on the bottom of alnico poles to help balance the tone of the pickup that have a vintage stagger on a guitar with a modern fretboard radius. Humbucker pickups with alnico magnets have a gauss reading of about .2K at the top of the slugs. A strat pickup with fully charged alnico 5 magnets will have a gauss of 1.2K. That's 6 times the magnetic pull which is why you need to keep strat pickups farther away from the strings than humbuckers. All adding neodymium does is make it so that you need to move the pickups even further away which is exactly why it works so well to help balance out pickups with a vintage stagger. Cita
Guest light a fan cool Inviato May 9, 2011 Segnala Inviato May 9, 2011 Come ti ho già scritto in MP non puoi farlo perchè i RW (Reverse Wound = Avvolti al contrario) sono anche di solito RP (Reverse Polarity = Polarità del magnete contrario allo standard) così da essere in controfase sì con le bobine, ma non c'è cancellazione di fase in quanto il magnete è contrario. Cita
Ric67 Inviato May 9, 2011 Segnala Inviato May 9, 2011 se inverti i fili ti suona secco secco senza corpo. Era capitato ad un amico che aveva saldato il pickup senza far caso ai fili... Cita
Guest MauroTheWall Inviato May 9, 2011 Segnala Inviato May 9, 2011 Ok, ora è tutto chiaro. Grazie a tutti, Dave, grazie anche per la risposta in PM. Adesso ho 2 alternative da provare: - Montare SSL-5 al ponte + 2 Voodoo (magari mettendo il Voodoo bridge in posizione centrale). - Provare il set completo dei Voodoo. Credo che opterò per la seconda delle 2, poi vedrò di trovare un centrale non reverse wound (anche se Florance dice reverse wind :TRsorrisone: ). Alla fine, quello che voglio è solo un po' più di spinta al ponte, non voglio sacrificare la posizione 2 per mettere un pickup più potente. Mgari più avanti valuterò l'ipotesi di un pickup col coil tap al ponte (come suggerito da Dave. Cita
Ric67 Inviato May 9, 2011 Segnala Inviato May 9, 2011 Boh... il verbo è To Wind : avvolgere. è un verbo irregolare..." Wound" è niente altro che "to wind" al passato ..."avvolto" mica l'ho capita sta precisazione prima!?!? in ogni caso Mauro, se metti il bridge al centro, occhio che fa 6.9K circa, magari è un po' carico. (mi pare che middle e neck stiano a 5.9-6.0) Cita
Guest MauroTheWall Inviato May 9, 2011 Segnala Inviato May 9, 2011 Boh... il verbo è To Wind : avvolgere. è un verbo irregolare..." Wound" è niente altro che "to wind" al passato ..."avvolto" mica l'ho capita sta precisazione prima!?!? in ogni caso Mauro, se metti il bridge al centro, occhio che fa 6.9K circa, magari è un po' carico. (mi pare che middle e neck stiano a 5.9-6.0) Che ti devo dire Ric? E' vero, Reverse wind è una gran cagata, si vede che Mr. Florance è un po' capra... :TRsorrisone: Appena finito di montare il set di Voodoo '70, stasera li proverò (sul pc...che merda) domani riusciroò a fare una prova poco più decente col cubetto. Cita
Guest light a fan cool Inviato May 9, 2011 Segnala Inviato May 9, 2011 Boh... il verbo è To Wind : avvolgere. è un verbo irregolare..." Wound" è niente altro che "to wind" al passato ..."avvolto" mica l'ho capita sta precisazione prima!?!? La precisazione stà che il pickup è avvolto... non è da avvolgere.... quindi Reverse WOUND è corretto. Reverse wind non sò Cita
Ric67 Inviato May 9, 2011 Segnala Inviato May 9, 2011 La precisazione stà che il pickup è avvolto... non è da avvolgere.... quindi Reverse WOUND è corretto. Reverse wind non sò non per farla lunga ..tanto checcefrega (la puntualizzazione l'aveva fatta qualcun altro)...ma forse "wind" in quel caso è un sostantivo? quindi Avvolgimento reverse? :TRsorrisone: Cita
pamaz Inviato May 9, 2011 Segnala Inviato May 9, 2011 il sostantivo sarebbe winding = avvolgimento Cita
santiaguito87 Inviato May 9, 2011 Segnala Inviato May 9, 2011 Ah ma allora non sono mie seghe mentali! I pickup che montavo prima sulla strato erano RW e nelle posizioni 2 e 4 sentivo come se perdessero "birra" e brillantezza. Poi ho cambiato PU (per cambio sonorità) con un set non RW e non sentivo lo stesso "calo di birra". Pensavo fosse una mia pugnetta (non ho l'orecchio così esperto) invece è un "problema" reale! Ma lo fanno per avere una sorta di effetto "hum cancelling"? Ma che me fotte, W l'hum della strato :TRsorrisone: Cita
Guest MauroTheWall Inviato May 9, 2011 Segnala Inviato May 9, 2011 Ah ma allora non sono mie seghe mentali! I pickup che montavo prima sulla strato erano RW e nelle posizioni 2 e 4 sentivo come se perdessero "birra" e brillantezza. Poi ho cambiato PU (per cambio sonorità) con un set non RW e non sentivo lo stesso "calo di birra". Pensavo fosse una mia pugnetta (non ho l'orecchio così esperto) invece è un "problema" reale! Ma lo fanno per avere una sorta di effetto "hum cancelling"? Ma che me fotte, W l'hum della strato :TRsorrisone: Sì, lo fanno per l'hum cancelling Cita
Ric67 Inviato May 10, 2011 Segnala Inviato May 10, 2011 ma la domanda vera è... perchè cappero dove rompermi i maroni con l'hum cancelling e poi avere la chitarra con un suonaccio? La strato ronza. punto. :) Cita
Guest MauroTheWall Inviato May 10, 2011 Segnala Inviato May 10, 2011 ma la domanda vera è... perchè cappero dove rompermi i maroni con l'hum cancelling e poi avere la chitarra con un suonaccio? La strato ronza. punto. :) Dopo averli provati stamattina sono d'accordo con te. Mi serve un Voodoo '70 non reverse. Il suono nelle posizioni 2 - 4 è meno scampanellante, più chiuso. Le altre posizioni sono ok, belli brillanti e spingono bene. Cita
Guest light a fan cool Inviato May 10, 2011 Segnala Inviato May 10, 2011 ma la domanda vera è... perchè cappero dove rompermi i maroni con l'hum cancelling e poi avere la chitarra con un suonaccio? La strato ronza. punto. :) Pensa te che io preferisco di gran lunga il suono in posizione 2 e 4 con il pickup centrale RW/RP, infatti la mia strato preferita è quella con i Fralin Vintage hot che hanno questo pickup in mezzo.... cioppa benissimo, alte controllate, mai sbrodolante sulle basse con un suono funky da sbavo. Cita
sunburst4blues Inviato May 10, 2011 Segnala Inviato May 10, 2011 domanda delle 15.41... i fralin e i lollar esistono solo con il middle reverse? Cita
Guest Massy Inviato May 10, 2011 Segnala Inviato May 10, 2011 sono arrivato tardi a vedere la discussione, cmq si, non puoi rigirare un pickup reverse wind semplicemente invertendo i fili...già è stato detto tutto...ora che ho provato un set NON RWRP (reverse wind reverse polarity) non torno più indietro...e sti cavoli senza ronza un po di piu... 1 Cita
Guest MauroTheWall Inviato June 2, 2011 Segnala Inviato June 2, 2011 Riuppo, oggi ho fatto una prova e non ci capisco più 'na sega. Ho smontato il Voodoo '70 centrale RWRP che prossimamente sarà trasformato in non reverse. Al suo posto volevo montare il centrale Custom '69 originale. E qui la prima sorpresa: riprendendo in mano i Custom '69 smontati lo scorso mese dalla Strato Black, mi accorgo che il centrale è RWRP, come il Voodoo. Ma io mi ricordavo che i Custom '69 non avevano il centrale RWRP . Mi sbaglio forse? Ho controllato sul sito Fender, ma non sono molto chiari al riguardo. Inoltre misurano 5.5K manico e ponte e 5.4K il centrale, mentre io mi ricordavo che i Custom '69 erano a 5.9K. Vabbè, poco male, prendo il pickup al manico e lo monto in posizione centrale, così mentre mi rifaranno il Voodoo la chitarra è a posto e posso sentire come suona con un centrale non RWRP. Collego il pickup, nero a massa e bianco allo switch, già che ci sono scollego il tono dal centrale e lo metto sul pu ponte e rimonto tutto. E qui la sorpresa, il pickup centrale è fuori fase :blink: . Da solo suona bene, ma in posizione 2-4 ho il tipico suono fuori fase, un poco più basso di volume e nasale. Non ci capisco una mazza, ho ricontrollato i collegamenti e sono giusti, c'è qualcosa che mi è sfuggito? AIUTO Cita
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.